Auto CPAP / CPAP System User Manual V1.0
39 / 51
(2) Cleaning the Transfer Box: Rinse the transfer box throughly in clean water. You may
also clean the transfer box with a soft cloth which does not scratch it (dip the soft cloth in
liquid soap if necessary), rinse it thoroughly, and then wipe it dry with a soft cloth.
(3) Returning the Transfer Box: As shown in Fig. 18-3.
Fig. 18-3
CAUTIONS!
• It is recommended to clean the transfer box once a week.
18.5 Cleaning the Enclosure
Wipe the surface of the device with a soft, slightly damp cloth.
CAUTION!
• The device can only be used after the enclosure is dry, so that no moisture enters the
device.
• It is recommended to clean the enclosure once a week.
18.6 Cleaning the Tubing
(1) Remove the tubing from the device and mask before cleaning.
(2) Clean the tubing in warm water which contains washing liquid, and then rinse it in clean
water thoroughly.
(3) After cleaning, air-dry the tubing in a cool, well-ventilated area, and avoid direct sunlight.
It takes approximately 30 minutes to completely air-dry the tubing. Check whether the
tubing is completely dry before re-use.
CAUTIONS!
• It is recommended to clean the tubing once a week.
18.7 Replacing the Air Filter / PM2.5 Filter
(1) Attach the air filter to the filter cap, as shown in Fig. 18-4.
Fig. 18-4
To Next Page
Loading...
Need help?
General
