Auto CPAP / CPAP System User Manual V1.0
23 / 51
Fig. 13-8
CAUTIONS!
• Generally speaking, the humidity inside the mask is low when the water temperature is low.
• The greater the difference between the temperature inside the air tubing and room
temperature is, the more easily condensation occurs inside the tubing.
• If there are only a few condensed water droplets inside the tubing in the morning after
therapy, it means that the humidity level is appropriate; if there is lots of condensed water
droplets inside the tubing and / or mask, it means that the humidity level is too high and
should be set lower; Nasal dryness means that the humidity level is too low and should be set
higher.
WARNING!
• Do not touch the heater plate of the device when it is working, otherwise you may get
burned. Turn off the heat when the heated humidifier is not in use.
14. Using the SpO
2
Kit
The SpO
2
Kit consists of a SpO
2
Probe and Connector, as shown in Fig. 14-1.
Fig. 14-1
14.1 Connecting the SpO
2
Kit to the Device
(1) Insert the SpO
2
Kit connector into the SpO
2
Kit Port of the device, as shown in Fig.
14-2.
To Next Page
Loading...
Need help?
General
