Auto CPAP / CPAP System User Manual V1.0
38 / 51
18.3 Cleaning the Water Chamber
(1) Opening the Water Chamber: Open the cap of the water chamber, as shown in Fig.
16-1.
Fig. 18-1
(2) Cleaning the Water Chamber: You may also clean the water chamber with a soft cloth
which does not scratch the water chamber (dip the soft cloth in liquid soap if necessary),
rinse it thoroughly, and then wipe it dry with a soft cloth.
(3) Returning the Water Chamber according to instructions in 13.1.3.
WARNINGS!
• Emptying and cleaning the water chamber daily will help prevent mold and bacteria
growth.
• Allow the water in the chamber to cool down to room temperature before removing it from
the device.
CAUTIONS!
• Clean the water chamber only after the water in it cools. Make sure that no water enters
the device.
• After cleaning, rinse the water chamber throughly in clean water to make sure that no soap
residue is left; then wipe it dry with a lint-free cloth, so as to prevent calcareous
accumulations.
• Inspect the water chamber for any leak or damage. Replace the water chamber if any
damage is present.
• It is recommended to do daily cleaning of the water chamber.
18.4 Cleaning the Transfer Box
(1) Removing the Transfer Box: First remove the water chamber from the device, and
then remove the transfer box, as shown in Fig. 18-2.
Fig. 18-2
To Next Page
Loading...
Need help?
General
