Removing front and rear
turn signal bulb
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Remove screw 1.
Pull glass on screw connection
side out of mirror housing.
Remove bulb 1 from
light housing by turning it
counterclockwise.
Installing front and rear
turn signal bulb
Replace defective bulb.
Bulbs for flashing turn
indicators, front
RY10W / 12 V / 10 W
To prevent contaminants from
being deposited on the new
bulb's glass surface, always use
a clean, dry cloth to hold it.
Install bulb 1 by screwing
clockwise into light housing.
8
109
z
Maintenance
ProCarManuals.com
To Next Page
Loading...
Need help?
General
