General instructions
The "Maintenance" chapter de-
scribes work involving the check-
ing and replacement of wear
parts that can be performed with
a minimum of effort.
If special tightening torques are
to be taken into account for
assembly, these are listed. An
overview of all required tightening
torques is contained in the
chapter "Technical Data".
Further information about main-
tenance and repair work can be
obtained on DVD through your
authorized BMW Motorrad re-
tailer.
Special tools and thorough spe-
cialized knowledge are required
to carry out some of the work. If
you are in doubt, consult a spe-
cialist service facility, preferably
your authorized BMW Motorrad
retailer.
Onboard tool kit
Standard tool kit
1 Screwdriver handle
2 Reversible screwdriver in-
sert
Phillips PH1 and Torx T25
Remove front and
rear turn signal bulb
( 109).
Replacing brake light and
tail light bulbs ( 108).
Remove center fairing
panel ( 110).
Removing battery
( 114).
Service tool kit
with service toolkit
OA
For more extensive work (such as
wheel removal and installation),
BMW Motorrad has put together
a service tool kit matched to your
motorcycle. You can purchase
this tool kit from your authorized
BMW Motorrad retailer.
8
88
z
Maintenance
ProCarManuals.com
To Next Page
Loading...
Need help?
General
