EN
9
CAUTION
Ensure that the Wallbox is not damaged by incorrect handling (housing cover, internal parts,
etc.).
Pull the charging cable out of the connector using only the charging cable plug, not the
cable.
Ensure that the charging cable is not mechanically damaged (kinked, jammed, or run over)
and that the contact area does not come into contact with heat sources, dirt, or water.
IMPORTANT
■
If it is raining or snowing and the Wallbox is installed outdoors, do not open the terminal
panel cover.
■
Wait until a current charging cycle has been finished and the vehicle has been
disconnected before you open the covers.
Intended use
The Wallbox is a charging station for indoor and outdoor use, designed to charge electric or
plug-in hybrid vehicles. Do not connect any other devices such as electric tools. The Wallbox is
designed for installation on a wall or a column. Comply with the relevant national regulations for
installing and connecting the Wallbox.
The intended use of the device in every case includes compliance with the ambient conditions for
which this device was developed.
The Wallbox was developed, manufactured, tested and documented on the basis of the relevant safety
standards. If you comply with the instructions and safety information described for its intended use,
the product will therefore not normally pose any danger in terms of property damage or to the health of
people.
This device must be earthed. In the event of an error, the earth connection will reduce the danger of an
electric shock.
The instructions contained in this manual must in any event be followed exactly. Otherwise, sources
of danger may be created or safety equipment may be rendered ineffective. In addition to the safety
information provided in this manual, the safety and accident prevention regulations relating to the
specific device must be followed.
As a result of technical or statutory restrictions, not all versions/options are available in all countries.
To Next Page
Loading...
Need help?
General
