107
DISASSEMBLY PROCEDURE
10. Rack Ear Removal
10.1 Remove the two screws that secure the rack
ear to the front panel. Lift off the rack ear.
11. Front Panel Removal
11.1 Perform procedure 1 to remove top cover.
11.2 Perform procedure 10 to remove rack ears.
11.3 Using a small at tip screwdriver, or similar,
carefully pry the front panel off from the front of
the chassis. The front panel is held in place with
six metal clips, three each on top and bottom, that
protrude from the front of the chassis. The front
panel should come straight off. Take care to not
mark the front panel assembly during this process.
12. OLED Display Removal
12.1 Perform procedure 11.
12.2 Once the front panel is removed, you should
be able to release the OLED display plastic carrier
from the front panel by pressing in on the display
carrier retaining tabs.
12.3 Lift out the display carrier. The OLED display
is held in place on the display carrier with a
pressure sensitive adhesive pad (PSA).
Note: The OLED display is not removeable from
the display carrier. The service part replacement
OLED display will come pre-mounted to a carrier.
13. Display Lens Removal
13.1 Perform procedure 12 to remove the OLED
display.
13.2 Lift out the Display Lens.
To Next Page
Loading...
Need help?
General
