11
SYSTEM SETUP
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
Connecting to AC power
1. Make sure the power switch is off.
2. Plug one end of the AC power cord into the AC Mains connector on
the power stand.
3. Plug the other end into a live AC (mains) receptacle (Figure 4).
Figure 4
Power connections
AC Mains
CAUTION: DO NOT block or cover
the handle opening, which is part of
the ventilation system. Doing so can
cause the L1
®
system to overheat,
switch to a thermal protection mode,
and temporarily turn off.
Power switch
CAUTION: Bose recommends using a quality surge suppressor on all electronic equipment.
Voltage variations and spikes can damage electronic components in any system. A quali
ty
suppressor, which can eliminate the vast majority of failures attributed to surges, may be
purchased at e
lectronics stores.
VeniceOG.book Page 11 Monday, April 30, 2012 2:33 PM
To Next Page
Loading...
Need help?
General