12
SYSTEM SETUP
EnglishDeutschFrançais DanskEspañolItalianoSvenska Nederlands ItalianoSvenska DeutschNederlands Français Español
Connecting the B1 or B2 bass module
You can place the B1 or B2 bass module either vertically or horizontally on the floor. It fits
neatly between the legs of the power stand.
1. Plug one end of the B1 or B2 bass module cable into one of the bass connectors. Rotate
the plug clockwis
e to lock it in place. You should hear a soft click as it locks.
2. Plug the other end of the cable into the Bass Module Out connector on
the power
stand. Rotate the plug clockwise to lock it.
Note:
To disconnect a B1 or B2 cable, slide back the metal tab on the body of the plug, rotate
the plug counterclockwise, and pull it out of the connector.
Figure 5
B1 and B2 bass modules
B1
Bass Module
Out
Bass Module
Out
B2
CAUTIONS:
• DO NOT connect any bass module other than the B1 or B2 to the power stand.
• DO NOT substitute the supplied cable with a 2-wire speaker cable. Use only the supplied
B1 bass modu
le 4-wire cable to connect the B1 bass module to the power stand. The
power stand uses the signals on two of the wires to automatically sense how many B1 or
B2 bass modules are connected.
• DO NOT connect a B1 or B2 bass module to two power stands at the same time.
VeniceOG.book Page 12 Monday, April 30, 2012 2:33 PM
To Next Page
Loading...
Need help?
General