Bose L1 model 1S system User Manual

15
OPERATING INFORMATION
English Deutsch FrançaisDansk Español Italiano SvenskaNederlandsItaliano SvenskaDeutsch NederlandsFrançaisEspañol
OPERATING INFORMATION
Setting the analog input level
When connecting an audio source to the Analog Input, follow these steps to adjust the input
Trim control.
1.
Set the Trim control on the power stand to the 0 (zero) position.
2. Connect the audio source to the Analog Input.
3. Adjust t
he volume of the audio source to the desired level.
4. While playing the source, increase the Tr
im level until the Signal/Clip ind
icator glows
green or yellow.
5. If the Signal/Clip indicato
r glows red, decrease the Trim level so that it glows only green
or yellow.
Using a T1 ToneMatch
®
audio engine and an analog input source
The L1
®
model 1S system can operate with both a T1 ToneMatch
®
audio engine and an
analog audio source connected to the power stand. However, keep in mind that the volume
level of the
audio engine and the analog audio source is adjusted independently.
• The power stand Trim control only a
ffects the volume level of the analog audio source con-
nected to the Analog Input. Theref
ore, the Signal/Clip indicator indicates the status only
of the analog input signal.
• The T1 ToneMatch audio engine has a Trim contr
ol and signal/clip indicator for each input,
a Volume control for each output channel, and a Master volume control that adjusts the
level of the ToneMatch output sent to the power stand. These controls have no effect on
the signal fed to the Analog Input.
User scenarios
There are many ways to set up and use this system with and without the T1 ToneMatch audio
engine. The following pages show examples of some typical user scenarios. When using the
T1 ToneMatch audio engine, refer to its owner’s guide for more information on setup and
operation.
Single musician
A solo musician might play a single instrument through the L1 model 1S system (Figure 1). 
A solo musician also might play an instrument and use a microphone for vocals (Figure 2 on
page 16).
Figure 1
Single system with
keyboard
VeniceOG.book Page 15 Monday, April 30, 2012 2:33 PM

Bose L1 model 1S system Specifications

General

Brand	Bose
Model	L1 model 1S system
Category	Amplifier
Language	English