NOTES:
The speaker wire and interconnect cables included with this system are not approved for in-wall installation.
Please check your local building codes for the correct type of wire and cable required for in-wall installation.
Where the mains plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
Due to ventilation requirements, Bose does not recommend placing the product in a confined space such as in
a wall cavity or in an enclosed cabinet.
Regulatory Information
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause undesired operation.
Bose Corporation hereby declares that this product is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and all other applicable
EU directive requirements. The complete declaration of conformity can be found at:
www.Bose.com/compliance.
Information About Products That Generate Electrical Noise (FCC Compliance Notice for US)
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at one’s own expense.
Changes or modifications not expressly approved by Bose Corporation could void the user’s authority to operate
this equipment.
Shielded cables are required to maintain regulatory compliance.
This product complies with the Canadian ICES-003 Class A specifications. CAN ICES-3(A)/NMB-3(A)
This product meets all EN55103-2 immunity requirements for E2 electromagnetic environment.
Names and Contents of Toxic or Hazardous Substances and Elements
To Next Page
Loading...
Need help?
General
