Brother MFC-8680DN User Manual

Control panel setup
101
6
e Press a or b to choose IPv6.
Press OK.
f Press a or b to choose On or Off.
Press OK.
g Press Stop/Exit.
Note
• If you set IPv6 to On, turn off the power switch and then turn it back on to enable this protocol.
• After you choose IPv6 On, this setting will be applied to both the wired and wireless LAN interface.
Ethernet (wired network only) 6
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (MFC-8890DW only)
Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Ethernet.
Press OK.
e Press a or b to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.
Press OK.
f Press Stop/Exit.
Setup Wizard (MFC-8890DW wireless network only) 6
The Setup Wizard guides you through the wireless network configuration. (For more information, see the
Quick Setup Guide or Using the Setup Wizard from the control panel on page 31.)

Brother MFC-8680DN Specifications

General

Brand	Brother
Model	MFC-8680DN
Category	All in One Printer
Language	English