General setup
25
3
Tray use in Copy mode
(MFC-5860CN only) 3
You can change the default tray the machine
will use for printing copies.
Auto Select will allow your machine to
take paper from Tray#2 if both trays are using
paper that is the same type and size and if
Tray#1 is out of paper.
To change the default settings follow the
instructions below:
a Press Menu, 1, 8.
b Press a or b to choose Tray#1 Only,
Tray#2 Only or Auto Select.
Press OK.
c Press Stop/Exit.
Note
You can only use plain paper sizes Letter,
Legal or A4 in Tray#2.
Volume Settings 3
Ring Volume 3
You can choose a range of ring volume
levels, from Off to High.
While in Fax mode , press d or c
to adjust the volume level. The LCD shows
the current setting, and each key press will
change the volume to the next level. The
machine will keep the new setting until you
change it.
You can also change the volume through the
menu, by following the instructions below:
Setting the Ring Volume from the
menu 3
a Press Menu, 1, 4, 1.
b Press a or b to choose Off, Low, Med
or High.
Press OK.
c Press Stop/Exit.
Beeper Volume 3
When the beeper is on, the machine will beep
when you press a key, make a mistake or
after you send or receive a fax.
You can choose a range of volume levels,
from Off to High.
a Press Menu, 1, 4, 2.
b Press a or b to choose Off, Low, Med
or High.
Press OK.
c Press Stop/Exit.
To Next Page
Loading...
Need help?
General
