VERTEX 70v User Manual 1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
S
AFETY
1
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
GENERAL INFORMATION
Read the following safety instructions carefully before putting the spectrometer into
operation. Keep this manual in a suitable place for future reference.
Always observe the instructions described in this manual to ensure user safety and to
avoid property damage. Improper use or failure to follow these safety instructions can
result in serious injuries and/or property damage. Any non-observance of the precau-
tions will infringe the intended use (i.e. performing spectroscopic measurements) of the
spectrometer. In this case Bruker Optik GmbH will not assume any liability.
It is the operator’s duty to plan and implement all necessary safety measures and to
supervise their observance. Moreover, the operator must ensure that the spectrometer
is in proper functioning condition. A safe and faultless operation can only be guaranteed
if the spectrometer is transported, stored, installed, operated and maintained properly
according to the procedures described in this manual.
Never remove or deactivate any supporting safety systems during spectrometer opera-
tion. Ensure that objects and/or material not required for the measurement is out of the
spectrometer operating area.
The spectrometer complies with the IEC/EN 61010-1 safety regulations.
Protective Earthing
To avoid personal injuries and/or property damage caused by electrical power, the
spectrometer is equipped with a safety plug. Connect this plug only to a socket outlet
with earthing contact. Make sure that the socket complies with IEC (International Elec-
trotechnical Commission).
Qualified Personnel
Primary installation and all maintenance and repair works not described in this manual
should only be performed by Bruker service personnel. Only authorized operating per-
sonnel that have been briefed about the spectrometer operation and all relevant safety
aspects should operate and maintain (i.e. only maintenance works that are described in
this manual) the spectrometer.
All repairs, adjustments and alignments on any spectrometer component must be per-
formed in accordance with the safety regulations and standards applied in the country in
which the instrument is installed.
To Next Page
Loading...
Need help?
General
