Bticino Sfera Keypad Module Installer Manual

24
4.3 Reset
It is also possible to reset the Sfera Keypad Module and delete all the previously set codes; this will
bring the module back to all the default settings.
3 The red LED
comes on for
4 seconds and
then switches
back off.
1 Disconnect the power
supply (BUS), press and hold
down the programming
pushbutton and reconnect
the power supply.
2 Holding down the
pushbutton until an
extended beep is heard.
OFF
OFF
ON
ON
OFF
OFF
ON
ON
4 Advanced configuration
In entrance panels with keypad and speaker module, wait one minute after the reset
procedure before starting the programming procedure again.

Bticino Sfera Keypad Module Specifications

General

Brand	Bticino
Model	Sfera Keypad Module
Category	Control Unit
Language	English