OPERATION MANUAL
38| 46
Switching the APD on and off with the remote control
To switch off the APD function with the remote control, press the (RESUME) button.
$
The front LED (2) briefly flashes red three times to confirm.
To switch the APD function back on with the remote control, press the (RESUME)
button again.
$
The front LED (2) briefly flashes green three times.
Switching the APD on and off via BurLink
Switching the APD on and off via BurLink is described in the section “BurLink”.
REMOTE
The remote connection allows you to switch your Burmester devices on or off
remotely. If you connect the REMOTE OUT (9) jack of the 218 to the corresponding
REMOTE IN jack on a Burmester device, you will be able to switch it on and off
remotely when switching the 218 on and off. In this operating mode, the 218 takes over
the master function.
If you connect the REMOTE IN (8) jack of the 218 to the corresponding REMOTE OUT
jack on a Burmester device, you will be able to switch the 218 on and off remotely
when switching the device in question on and off. In this operating mode, the 218 is
relegated to the slave function.
To Next Page
Loading...
Need help?
General
