218 POWER AMPLIFIER
39| 46
TYPE Device type
VERSION Firmware version
SNR Serial number
POWOFF Switching off the device
POWON Switching on the device
APD Switching Auto Power Down on/off
IR Switching the infrared sensor on/off
INFO Output of TYPE, VERSION, SNR, IR status and device
status (device status: STBY: NOT ON!, ON: APD:
ONSTATUS, ERROR: ERRTYPE)
BURLINK
Control systems such as PC, CRESTRON®, Nevo etc. can be connected to the
BurLink connection. These allow convenient control of your entire system,
e.g. via an individually programmable touch panel.
The BurLink interface can be operated via the 9-pin D-SUB jack (RS-232). RS-232
configuration: 9600 Baud, 8 bit, parity: none, 1 stop bit, no hardware handshake.
The possible commands for operating the 218 are listed below. The commands must
be sent in capital letters. All BurLink commands must end with CR or $0d.
To Next Page
Loading...
Need help?
General
