Technical Data
Model 0025 0040 0063 0100 0101 0250
Nom. pumping speed (ACFM)
18 26 36 56 71 170
Free air displacement (CFM)
20 28 41 63 77 180
Maximum sound level (dBa)
70 70 70 71 71 81
3 phase motor data (HP*)
1 1/2 2 3 5 5 10
1 phase motor data (HP*)
1 1/2 2 3 5 5 N/A
Approx. oil capacity (qts)
1.4 1.4 2.5 2.7 2.7 7
Inlet connection - NPT (inch)
1 1/4 1 1/4 1 1/4 1 1/4 1 1/4 2
End vacuum - RC (Torr)
15 15 15 15 15 15
End vacuum - RA (Torr)
0.5 0.5 0.5 0.5 0.5 0.5
Approx. weight (lbs)
106 120 172 198 198 460
Notes: *Because various motor types might be available and/or used on your specific pump, you should always refer to the motor nameplate
to verify HP, volts, amps, frame size, etc. or consult the factory.
oil (0250 models).
Remedy:
Remove the oil cooler and flush. Pump may have to be
disassembled completely to correct a severely contam-
inated condition.
5.0 LIMITED STANDARD WARRANTY
Busch, Inc. warrants that all products furnished by it are
free from defects in material and workmanship at the
time of shipment for a period of 18 months from the
date of shipment, or 12 months from the date of instal-
lation, whichever occurs first. Claims must be made
during that period and are limited to the replacement or
repair of parts claimed to be defective.
In the case of components purchased by Busch, Inc.,
such as starters, controls, mechanical seals, motors,
couplings, etc., the warranty of that manufacturer will be
extended to the purchaser in lieu of any warranty by
Busch, Inc. The replacement of wear items including,
but not limited to, seals, bearings, couplings, exhaust
cover gaskets, oil drain plugs, oil fill plugs etc., made in
connection with normal service are not covered by this
Warranty.
The Limited Standard Warranty is valid only when the
product has been properly installed, used in a normal
manner, and serviced according to the operating man-
ual. This warranty shall not extend to products that
have been misused, neglected, altered, or repaired
without factory authorization during the warranty period.
We highly recommend the use of Busch oils and parts
to achieve documented performance and efficient oper-
ation. The use of oils or parts other than Busch could
limit the life expectancy of the equipment and could void
any warranties if they are the cause of any damage.
Operating conditions beyond our control such as
improper voltage or water pressure, excessive ambient
temperatures, or other conditions that would affect the
performance or life of the product will also cause the
warranty to become void.
Permission to return parts for warranty repair must be
obtained, and all returns must be prepaid to the factory.
If, after examination, the product or part is found to be
defective, it will be repaired or replaced on a no-charge
basis and returned, FOB the factory. If it is determined
that the Warranty has not been breached by Busch,
Inc., then the usual charges for repair or replacement
will be made, FOB the factory. Parts or products that
are obsolete or those made to special order are not
returnable.
This Limited Standard Warranty applies only to the
above and is for the period set forth. Busch, Inc.'s max-
imum liability shall not, in any case, exceed the contract
price for the product, part, or component claimed to be
defective; and Busch, Inc. assumes no liability for any
special, indirect, or consequential damages arising
from defective equipment.
THERE ARE NO WARRANTIES IMPLIED OR
EXPRESSED THAT EXTEND BEYOND THOSE
CONTAINED IN THIS LIMITED STANDARD
WARRANTY.
Note: For extended warranties on your new equipment
contact Busch, Inc. Headquarters at 1-800-USA-PUMP.
14