1918
Preventing Malfunctions
● Avoid Strong Magnetic Fields
Never place the camera in close proximity to electric motors or other equipment generating strong
electromagnetic fields.
Exposure to strong magnetic fields may cause malfunctions or corrupt image data.
● Avoid Condensation Related Problems
Moving the equipment rapidly between hot and cold temperatures may cause condensation (water droplets) to
form on its external and internal surfaces. You can avoid this by placing the equipment in an airtight, resealable
plastic bag and letting it adjust to temperature changes slowly before removing it from the bag.
● If Condensation Forms Inside the Camera
Stop using the camera immediately if you detect condensation.
Continued use may damage the equipment. Remove the CF card and battery or power cord (if connected) from
the camera and wait until the moisture evaporates completely before resuming use.
● Extended Storage
When not using the camera for extended periods of time, remove the batteries from the camera or battery
charger and store the equipment in a safe place. Storing the camera for extended periods with batteries
installed will run down the battery and may damage the camera.
● Read this First ●
Installing the Battery and CF Card
Insert two (2) AA-size alkaline batteries (included
with the camera) or two (2) NiMH batteries (sold
separately) and insert the CF card.
1
Be sure that the camera power is off.
2
Slide the CF card slot / battery cover
and open the battery cover.
3
Insert the batteries as shown and
close the battery cover.
4
Insert the CF card as shown.
Slide the CF card firmly to the end. To release
the CF card, hold onto it and remove.
Preparing the Camera
(–) Negative end (+) Positive end
Battery Cover
To Next Page
Loading...
Need help?
General
