25
ADVANCED WI- FI
SETTINGS
The Côr Thermostat provides you the most features and energy savings when connected to your personal web portal. Your thermostat
supports Wi- Fi 802.11 b/g/n. Wi- Fi is normally configured during initial setup. You may, however, need to reconfigure the settings if your
Wi- Fi network settings change.
On Thermostat:
Touch Menu > Settings > Wi- Fi
Manual Configuration
The list of available networks appears in the Network menu. If your network doesn’t appear, you can enter the SSID manually by touching
Manually configure Wi-Fi from the bottom of the list.
After selecting or entering the SSID, you can configure the following parameters:
S Connect to IP using: Select DHCP to automatically connect, select Static IP to type in your own values (if unsure, leave DHCP Enabled).
S SSID Encryption: Your thermostat supports WEP, WEP128, WPA, and WPA2 encryption schemes.
S Password (if encryption is used)
S Channel: Leave any channel selected unless your network is configured to use a specific Wi- Fi channel.
Advanced Settings
If you are using Static IP addressing, the following additional parameters will require configuration:
S IP Address
S Gateway
S Subnet Mask
S Primary and Secondary DNS
If you need to specify your thermostat’s MAC address in your router’s configuration, you can obtain it from Menu > Settings > W i- Fi >
Diagnostics > Wi- Fi Details
Diagnostics
Your thermostat contains extensive diagnostic tools to help troubleshoot issues:
S Wi- Fi Details: Displays key network details as well as router and server connection status.
S View Log: Displays log file information about Wi- Fi operation.
S Ping Gateway: Checks to see if the network gateway is responding.
S Ping Carrier.com: Checks to see if the Carrier servers are responding.
S Ping Address: Checks to see if the entered IP address is responding.
On Thermostat:
1. Touch Menu > Settings > Wi- Fi > Diagnostics
2. Select the tool you wish to use.
To Next Page
Loading...
Need help?
General
