Cascade D Series Service Manual

2
669224-R5
NSTALLATION
I
WARNING: Rated Capacity of the truck/
attachment combination is a responsibility
of the original truck manufacturer and may
be less than that shown on the attachment
nameplate. Consult the truck nameplate.
GA0380.eps
Truck Relief Setting
2000 psi (140 bar) Recommended
2300 psi (160 bar) Maximum
Truck Flow Volume
➀
Min.
➁
Recommended Max.
➂
25D
4 GPM
(15 L/min.)
5.5 GPM
(21 L/min.)
5.5 GPM
(21 L/min.)
35D
4 GPM
(15 L/min.)
7 GPM
(26 L/min.)
7 GPM
(26 L/min.)
40D, 50D
4 GPM
(15 L/min.)
10 GPM
(38 L/min.)
10 GPM
(38 L/min.)
70D, 80D, 100D
7 GPM
(26 L/min.)
12 GPM
(45 L/min.)
15 GPM
(57 L/min.)
➀ Cascade D-Series Clamps are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁ Flow less than recommended will result in unequal arm
movement.
➂ Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.
Carriage Mount Dimension (A) ITA (ISO)
Minimum Maximum
Class II
Class III
Class IV
14.94 in. (380.0 mm)
18.68 in. (474.5 mm)
23.44 in. (595.5 mm)
15.00 in. (381.0 mm)
18.74 in. (476.0 mm)
23.50 in. (597.0 mm)
A
GA0028.eps
Carriage – Clean and inspect
carriage bars. Make sure the bars
are parallel and that ends are flush.
Repair any damaged notches.
GA0082.eps
Hoist Down
Hoist Up
Tilt Forward
Tilt Backward
Sideshift Left
Sideshift Right
Open
Clamp
Auxiliary Valve Functions
Check for compliance with ITA (ISO) Standards:
2.1 Truck Requirements

Cascade D Series Specifications

General

Brand	Cascade
Model	D Series
Category	Power Tool
Language	English