Cascade H Series User Manual

16
PERIODIC MAINTENANCE
6095756-R2 EN
2000-Hour Maintenance
After each 2000 hours of truck operation, in addition to the
daily and 1000-hour maintenance, perform the following
maintenance procedures:
• Check all rotation bearing capscrews for proper torque
value. See Technical Bulletin TB183 for checking and
replacement procedures.
• Inspect all arm and cylinder pivot pins for wear.
Replace if necessary.
4000-Hour Maintenance
After each 4000 hours of truck operation, in addition to
the daily, 1000 and 2000-hour maintenance, perform the
following maintenance procedures:
• Due to normal mechanical wear and component service
life, cylinder seals should be replaced to maintain
performance and safe operation. Refer to H-Series
Fixed Frame Pivot Arm Paper Roll Clamp Service
Manual 6078255, Section 4.4, for cylinder service.
WARNING: After completing any service
procedure, always test the attachment
through five complete cycles. First test
the attachment empty, then test with a load
to make sure the attachment operates
correctly before returning it to the job.
1000-Hour Maintenance
(continued)
• Inspect all arm, frame and cylinder pivot bushings for wear.
Replace if necessary.
• Inspect all load bearing structural welds on arms, swing
frame pivots, arm pivots and cylinder pivot areas for visual
cracks. Replace components as required.

Cascade H Series Specifications

General

Brand	Cascade
Model	H Series
Category	Power Tool
Language	English