Resetting Today’s Step
Count
1.
Enter the Timekeeping Mode.
l
Navigating Between Modes
2.
Hold down (B) and (D) for about two
seconds.
This resets the step count.
Specifying a Daily Step
Target
You can specify a daily step goal within the
range of 1,000 to 50,000, in units of 1,000
steps.
1.
Enter the Timekeeping Mode.
l
Navigating Between Modes
2.
Hold down (A) for about two seconds.
Release the button when [SET] stops
flashing.
●
This causes the current daily step target
to flash.
3.
Use (D) and (B) to change the daily step
target setting.
4.
Press (A) to exit the setting screen.
Causes of Incorrect Step
Count
Any of the conditions below may make proper
counting impossible.
●
Walking while wearing slippers, sandals, or
other footwear that encourages a shuffling
gait
●
Walking on tile, carpeting snow, or other
surface that causes a shuffling gait
●
Irregular walking (in a crowded location, in
a line where walking stops and starts at
short intervals, etc.)
●
Extremely slow walking or extremely fast
running
●
Pushing a shopping cart or baby stroller
●
In a location where there is a lot of vibration,
or riding on a bicycle or in a vehicle
●
Frequent movement of the hand or arm
(clapping, fanning movement, etc.)
●
Walking while holding hands, walking with
a cane or stick, or engaging in any other
movement in which your hand and leg
movements are not coordinated with each
other
●
Normal daily non-walking activities
(cleaning, etc.)
●
Wearing the watch on your dominant hand
●
Walking for 10 seconds or less
●
Watch hand movement (by the hand shift
function, etc.)
Stopwatch
The stopwatch measures elapsed time in
1/100-second units for the first hour, and in 1-
second units after that for up to 24 hours.
In addition to normal elapsed time
measurements, the stopwatch also lets you
take split time and lap time readings. You can
also set a target time and monitor your
progress in attaining it. You can configure
settings so the watch alerts you with a beeper
and/or display indicator when you attain your
target.
Note
●
Up to 200 split time and lap time
records can be stored in watch
memory. Perform a lap or split time
operation while there are already 200
records in memory will cause the
oldest record to be deleted
automatically to make room for the new
one.
●
You can use the Recall Mode to view
the latest measurement data.
l
Viewing Data Records
●
You can use G-SHOCK Connected to
view past measurement data.
Getting Ready
Enter the Stopwatch Mode.
l
Navigating Between Modes
Operation Guide 5554
10
To Next Page
Loading...
Need help?
General
