4.
Press (C).
This causes the minute digits to flash.
5.
Use (D) and (B) to change the minute
setting.
6.
Press (A) to exit the setting screen.
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
Enabling/Disabling an Alarm
or the Hourly Time Signal
1.
Press (D) to scroll through alarm numbers
([AL1] to [AL5]) and the hourly time signal
([SIG]) screens until the one you want to
configure is displayed.
Alarm or hourly time signal
2.
Press (B) to toggle the displayed alarm or
the hourly time signal between on and off.
[On]: On
[--]: Off
Stopping an Alarm
Pressing any button while the beeper is
sounding stops it.
Determining an Alarm’s
On/Off Status
Turning on an alarm or the hourly time signal
causes the corresponding indicator to appear
on the display. The alarm on indicator is
displayed when one or more alarm is turned
on.
Adjusting the Time
Setting Manually
When there is no communication with a
phone, the time and date can be adjusted with
the procedure below.
Getting Ready
Enter the Timekeeping Mode.
l
Navigating Between Modes
Setting the Time/Date
1.
Hold down (A) for about two seconds.
Release the button when [SET] stops
flashing.
2.
Keep pressing (C) until the setting you
want to change is flashing.
●
Each press of (C) moves the flashing to
the next setting in the sequence shown
below.
Day
Month
Ye a r
Minute
Hour
Seconds
12/24-hour timekeeping
Illumination duration
Operation tone enable/disable
Daily step target
Operation Guide 5554
17
To Next Page
Loading...
Need help?
General
