Casio 5618 User Manual

Stopwatch
The stopwatch measures elapsed time in
1/1000-second units for the first hour, and in
1/10-second units after that for up to 24 hours.
In addition to normal elapsed time
measurements, the stopwatch also lets you
measure lap times.
Note
●
Up to 200 lap time records can be
stored in watch memory. Performing a
split time operation while there are
already 200 records in memory will
cause the oldest record to be deleted
automatically to make room for the new
one.
●
You can use EDIFICE Connected to
view past measurement data.
Measuring Elapsed Time
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
D
D
D
D
Stop
Resume
Stop
Start
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
1/1000 seconds
Seconds, 1/10 seconds
After first hour
First hour
Minutes,
seconds
Hours,
minutes
3. Press (B) to reset the elapsed time to all
zeros.
Measuring Lap Times
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to measure
elapsed time.
●
Each press of (B) causes the elapsed
time of the section (lap time) to be
shown for eight seconds.
D
B
D
Stop
Start
Lap
●
Elapsed time is shown in 1/1000-
second units for the first hour of the
measurement session. After the first
hour, elapsed time is shown in 1/10-
second units.
1/1000 seconds
Lap time seconds
Seconds, 1/10 seconds
Lap time seconds
After first hour
First hour
Minutes,
seconds
Hours,
minutes
3. Press (B) to reset the elapsed time to all
zeros.
Example: Recording a Race
Lap Time
This section explains how to record lap times
while watching a race. It also shows how you
can view lap times with EDIFICE Connected
after the race is over.
l
Lap Times
During a race
Measure lap times.
1. Enter the Stopwatch Mode.
l
Navigating Between Modes
2. Use the operations below to perform a
timer operation.
D
B
B
D
Stop
Start
Pressing (B) at the end of each lap will
record them in watch memory.
●
Lap times are recorded in 1/1000-
second units during the first hour of an
elapsed time measurement session.
After one hour, times are recorded in
1/10-second units.
3. Press (B) to reset the elapsed time to all
zeros.
4. Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
After a race
After the race is finished, you can view the
measured lap times with EDIFICE Connected.
l
Sending Stopwatch Data to a Phone
l
Checking a Lap Time
Operation Guide 5618
10

Casio 5618 Specifications

General

Brand	Casio
Model	5618
Category	Watch
Language	English