Casio 5618 User Manual

Configuring Alarm Settings
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to scroll through alarm numbers
([AL1] to [AL5]) until the number of the
alarm you want to configure is displayed.
Alarm number
Alarm time
3. Hold down (B) for at least two seconds.
Release the button when the hour digits
start to flash.
Hours
4. Use (A) and (D) to change the hour setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
5. Press (C).
This causes the minutes digits to flash.
Minutes
6. Use (A) and (D) to change the minute
setting.
7. Press (B) to exit the setting screen.
8. Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
● To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper will sound for 10 seconds to
let you know when the alarm time is
reached.
●
You can also use EDIFICE Connected
to configure alarm time settings.
Configuring the Hourly Time
Signal Setting
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (D) to display the hourly time signal
screen ([SIG]).
3. Press (B) to toggle the hourly time signal
between enabled (on) and disabled (off).
●
[SIG] (hourly time signal) is shown on
the display while the hourly time signal
is enabled.
4. Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
Note
●
You can also use EDIFICE Connected
to configure the hourly time signal
setting.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (D) to scroll through alarm numbers
([AL1] to [AL5]) and the hourly time signal
([SIG]) screens until the one whose setting
you want to change is displayed.
Alarm or hourly time signal
3. Press (B) to turn off the displayed alarm or
the hourly time signal.
●
Each press of (B) toggles between ON
and OFF.
●
Turning off all alarms will cause [ALM]
(alarm) to disappear from the display,
while disabling the hourly time signal
causes [SIG] (hourly time signal) to
disappear from the display.
4. Hold down (C) for at least two seconds to
return to the Timekeeping Mode.
Note
●
If [ALM] (alarm) is still displayed, it
means that another alarm is still turned
on. To turn off all of the alarms, repeat
steps 2 and 3 until the [ALM] (alarm)
indicator is no longer displayed.
Operation Guide 5618
12

Casio 5618 Specifications

General

Brand	Casio
Model	5618
Category	Watch
Language	English