Using the Watch in a Medical
Facility or Aircraft
When you are in a hospital, on an aircraft, or
in any other location where radio signals may
cause problems, you can perform the
procedure below to disconnect the watch from
your phone so they can’t communicate with
each other (Airplane Mode). Use the same
procedure when you want to disable the
Airplane Mode.
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least two seconds.
Release the button when the name of the
currently selected Home City appears on
the display.
3. Press (C) 15 times.
This displays the Airplane Mode icon.
4. Press (D) to toggle between the Airplane
Mode settings.
[ON]: Airplane Mode enabled.
[OFF]: Airplane Mode disabled.
5. Press (B) to exit the setting screen.
Using Mobile Link with
a Mobile Phone
While there is a Bluetooth connection
between the watch and phone, the watch time
setting is adjusted automatically. You can also
change the watch’s other settings.
Note
●
This function is available only while
EDIFICE Connected is running on the
phone.
●
This section describes watch and
phone operations.
X
: Watch operation
Y
: Phone operation
Getting Ready
To use your watch in combination with a
phone, you first need to pair them. Perform the
steps below to pair the watch with a phone.
●
A
Install the required app on your
phone.
In Google Play or the App Store, search for the
CASIO “EDIFICE Connected” app and install
it on your phone.
●
B
Configure Bluetooth settings.
Enable the phone’s Bluetooth.
Note
●
For details about setting procedures,
see your phone documentation.
●
C
Pair the watch with a phone.
Before you can use the watch in combination
with a phone, you first need to pair them.
1. Move the phone to be paired with close to
(within one meter of) the watch.
2.
Y
Tap the “EDIFICE Connected” icon.
3.
Y
Perform the operation shown on the
screen of the phone to be paired with.
●
If your phone is already paired with a
watch, tap , tap the item for
connecting with a new watch, and then
tap this watch’s name.
●
If a pairing prompt message appears,
perform the operation shown on the
phone screen.
●
[CNCT] will flash on the watch display
when pairing starts. [OK] will be
displayed when pairing is complete.
Pairing complete.Pairing started.
Auto Time Adjustment
Your watch can connect with your phone to
adjust the watch’s time setting.
If you leave your watch in the Timekeeping
Mode, it will perform the adjustment operation
automatically as you go about your daily life,
without any operation required by you.
Important!
●
The watch may not be able to perform
auto time adjustment under the
conditions described below.
ー
While the watch is too far away from
its paired phone
ー
While communication is not possible
due to radio interference, etc.
ー
While the phone is updating its
system
ー
While EDIFICE Connected is not
running on the phone
Note
●
If the watch does not indicate the
correct time even if is able to connect
with a phone, adjust the hand and date
indicator positions.
l
Adjusting Hand Alignment
●
If there is a World Time City specified
with EDIFICE Connected, its time will
also be adjusted automatically.
●
Auto time adjustment is performed at
the times described below.
ー
After your phone’s time zone or
summer time setting is changed
ー
After 24 hours or more have passed
since the last time adjustment using
Bluetooth connection
ー
After 24 hours or more have passed
since city swapping using EDIFICE
Connected or watch operation
ー
After 24 hours or more have passed
since the last home city change or
time adjustment using watch
operation
●
Watch operation can be performed
even while it is connected with your
phone.
Operation Guide 5618
6
To Next Page
Loading...
Need help?
General
