3. Use (A) and (D) to change the timer hours
setting.
●
Holding down (A) or (D) scrolls through
settings at high speed.
4. Press (C).
This causes the minutes digits to flash.
5. Use (A) and (D) to change the timer
minutes setting.
6. Press (C).
This causes the seconds to flash.
7. Use (A) and (D) to change the timer
seconds setting.
8. Press (B) to complete the setting
operation.
Note
●
Setting a start time of [0:00'00]
performs a countdown of 24 hours.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Timer
1. Enter the Timer Mode.
l
Navigating Between Modes
●
The mode hand points the remaining
timer time. The mode hand points to
[OVER] when the remaining time
exceeds 120 minutes.
2. Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Measurement operation starts.)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (B).
3. Press any button to stop the tone.
Hand Alignment
Adjustment
Strong magnetism or impact can cause the
time indicated by the analog hands to become
different from the time on the digital display. If
this happens, adjust hand alignment.
Using CASIO WATCHES to
Adjust Hand Alignment
If the watch is paired with a phone, you can
also use CASIO WATCHES to adjust hand
alignment.
l
Adjusting Hand Alignment
Adjusting Hand Alignment
1. Enter the Timekeeping Mode.
l
Navigating Between Modes
2. Hold down (B) for at least five seconds.
Release the button when [00] starts to
flash.
This enables adjustment of mode hand
alignment.
After five secondsAfter 3.5 seconds
Mode hand
3. If the mode hand is not aligned with [00],
use (A) and (D) to align it with [00].
●
Holding down (A) or (D) moves the hand
at high speed.
Watch Operation Guide 5686
21
To Next Page
Loading...
Need help?
General
