Casio 5713 User Manual

Alarm
The watch will beep when an alarm time is
reached. You can set up to five different
alarms. The hourly time signal causes the
watch to beep every hour on the hour.
●
The beeper will not sound if battery power
is low.
Using the CASIO WATCHES
Phone App to Configure
Alarm Settings
If the watch is paired with a phone, you can
also use CASIO WATCHES to set alarms.
l
Configuring Watch Settings
Configuring Alarm Settings
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Use (A) and (C) to select the alarm number
([AL1] to [AL5]) whose setting you want to
change.
Alarm time
Alarm number
3. Loosen the crown and then pull it out.
This causes the hours and minutes digits
to flash.
Hours
Minutes
Crown
4. Rotate the crown to change the minute
setting.
●
The hour digit changes in sync with the
minute digit change.
5. Press (B).
This causes the hours digits to flash.
Hours
6. Rotate the crown to change the hour
setting.
●
If you are using 12-hour timekeeping,
the time setting is indicated as [A] (a.m.)
or [P] (p.m.).
7. Push the crown back in and then lock it.
Note
●
If you do not perform any operation for
about three minutes while in the Alarm
mode, the watch automatically returns
to the Timekeeping Mode.
●
If you do not perform any operation for
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
●
To stop the alarm
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
●
A beeper sounds for 20 seconds when
an alarm time is reached.
Enabling the Hourly Time
Signal
1. Enter the Alarm Mode.
l
Navigating Between Modes
2. Press (A) or (C) to display the hourly time
signal screen ([SIG]).
3. Press (D) to toggle the hourly time signal
between enabled and disabled.
●
(hourly time signal) is shown on the
display while the hourly time signal is
enabled.
Turning Off an Alarm or the
Hourly Time Signal
To stop an alarm or the hourly time signal from
sounding, perform the steps below to turn it
off.
●
To have an alarm or hourly time signal
sound again, turn it back on.
Note
●
Indicators are displayed while any of
the alarms or the hourly time signal is
turned on.
●
The applicable indicators are not
displayed while all of the alarms are
turned off and/or the hourly time signal
is turned off.
Alarm
Hourly time signal
Watch Operation Guide 5713
30

Casio 5713 Specifications

General

Brand	Casio
Model	5713
Category	Watch
Language	English