E-18
Removing
1. Make sure that the Handheld Terminal is turned off.
If the power is on, press the power key to turn it off.
2. Turn the terminal over, turn the left and right lock switches for the battery pack cover
to the “FREE” position (
), and then remove the battery pack cover ( ).
3. Remove the battery pack by pulling up the removal tape as shown in the illustration.
Important!
When removing the battery pack, make sure you do not leave the Handheld
Terminal without a battery pack for more than about 10 minutes. Doing so can
cause data in the memory to be deleted.
When removing the battery pack, be sure you carefully follow the proper
procedure as explained in this guide.
Never try to use other type of battery than the ones that are specifi ed for this
product.
When removing the battery pack, pull the removal tape straight up and remove
the battery pack. Removing with excessive force can damage the battery pack.
Before starting to use the Handheld Terminal, ensure that the battery pack cover
is properly closed. If not, the power is not turned on or is turned off abruptly
while it is in use.
When the hand belt is attached to the terminal, loosen the hand belt before
opening or closing the battery pack cover. Pulling with excessive force could
damage the hand belt or hand belt mount.
•
•
•
•
•
•
To Next Page
Loading...
Need help?
General