Casio DT-X200 Series User Manual

E-40
Handling the Hand Belt (HA-K95HB)
An optional hand belt (HA-K95HB) can be attached to the terminal.
Attaching the hand belt
1. As shown in the fi gure, align the metal part of the hand belt hook in line with the
installation position on the terminal and then snap it into the ditch. Make sure that the
metal part is fi rmly seated.
2. Thread one end of the hand belt through the hand belt hook. Then fold it back and set
the belt in proper length by adjusting the hook-loop fastener.
Removing the hand belt
1. As shown in the fi gure, pull out the metal part of the hook while pressing down the
protrude part that has a small dimple on it.
2. Loose the hook-loop fastener and then pull out the belt through the hand belt hook as
shown in the fi gure.

Casio DT-X200 Series Specifications

General

Brand	Casio
Model	DT-X200 Series
Category	Handhelds
Language	English