— 9 —
Removing the Battery Holder/Battery Pack
1. Make sure the terminal is turned OFF.
2. Turn the terminal over and slide the two battery cover lock switches 1 & 2 on the sides of the Handheld
Terminal to the “FREE” position.
3. Remove the battery cover .
4. Remove any alkaline batteries , if they are installed.
5. Remove the alkaline battery holder (or battery pack ) by pushing the tab 7 on the frame of the holder,
and pulling the battery pack removal tape 8 upwards.
Figure 2 - 1 - Removing the Alkaline Battery Holder
3. Battery Cover
4. Alkaline Batteries
5. Battery Holder
6. Battery Pack
3
4
5 6
To Next Page
Loading...
Need help?
General