Reception OK?
Reception OK?
Check the Receiving Station
START
AUTO Reception
"Insufficient Signal" may also be the reason
for the signal receiving fault.
Perform the test in “MANUAL Reception”
or “Time Calibration Signal Test mode”.
Insufcient Signal
The time calibration signal may not be properly received under the following conditions.
• The strength of the signal has changed due to season or time of day
• The watch is placed in the reinforced concrete building
• There is a broadcasting station nearby
• Strong enough signal cannot be received due to the position of the watch
The signal used for the local time setting differs from that for the facility testing in China using TEM cell.
* For the local time calibration signal, use the normal mode.
* To check the signal using TEM cell, perform the inspection in the Test Mode.
MANUAL/AUTO Reception7-9-1.
To change the signal station, you may easiliy do so by using the test mode in P.12 [ CONFIGURING
HOME CITY ] For details of MANUAL and AUTO reception modes, refer to the Operation Guide.
MANUAL Reception
While on the Timekeeping mode, press
A
for two seconds. The Mode Hand moves to “Ready (R)”
position. While receiving signals, the Mode hand indicates “Work (W)” position and reception is
enabled (LCD 1: GET; if signal cannot be received, the LCD 1 shows ERR). Press
A
or wait for 1 – 2
minutes to return to the Timekeeping mode.
* Press any button to end the manual reception or the reception result display and return to the normal
Time Keeping Mode.
AUTO Reception
Turn on the AUTO Reception setting. When AUTO Reception is turned ON, the calibration signal is
automatically received up to 6 times from midnight through early
morning.
(If reception is successful once, the subsequent AUTO reception
will not be conducted on the same day.)
* To check whether the calibration signal was received
successfully, press
A
and determine by the position of the
indicator.
(The LCD 1 indicates GET if successful, and ERR if failed)
To Next Page
Loading...
Need help?
General