150
Other Settings (Set Up)
Procedure
[MENU] * Set Up Tab * REC/PLAY
• With “Power On/Off”, the camera turns off when you press [r] (REC) in the REC
mode or [
p] (PLAY) in the PLAY mode.
• Change this setting to “Power On” or “Power On/Off” before connecting to a TV for
image viewing.
Procedure
[MENU] * Set Up Tab * USB
You can use the procedure below to select the USB communication protocol, which is
used when exchanging data with a computer, printer, or other external device.
Configuring [r] and [p] Settings (REC/PLAY)
Power On
Camera turns on whenever [
r] (REC) or [p] (PLAY) is
pressed.
Power On/Off
Camera turns on or off whenever [
r] (REC) or [p] (PLAY) is
pressed.
Disable
Camera does not turn on or off when [
r] (REC) or [p] (PLAY)
is pressed.
Configuring USB Protocol Settings (USB)
Mass Storage
Select this setting when connecting to a computer (pages 126,
135). With this setting, the computer sees the camera as an
external storage device. Use this setting for normal transfer of
images from the camera to a computer.
PTP
(PictBridge)
Select this setting when connecting to a printer that supports
PictBridge (page 117). This setting simplifies the transfer of image
data to the connected device.
To Next Page
Loading...
Need help?
General
