32
Snapshot Tutorial
1. In the REC mode, press [SET].
2. Use [8] and [2] to select the fourth Control Panel option from the top
(Sensitivity).
3. Use [4] and [6] to select the sensitivity setting you want, and then
press [SET].
• You can select any one of three sensitivity levels, from ø (Lowest) to
œ (Highest).
• With the œ (Highest) setting, the auto shutter release is triggered relatively
easily. Auto shutter release triggering becomes more difficult with the ø
(Lowest) setting, but recorded images have the least blur. Experiment with
Auto Shutter trigger sensitivity settings to find the one that work best for you.
. Using Auto Shutter in Combination with Continuous Shutter
The following describes how Auto Shutter works while used in combination with
Continuous Shutter (page 39).
To change Auto Shutter trigger sensitivity (Sensitivity)
With Normal Speed
Continuous Shutter
The camera will go back into Auto Shutter standby and be
ready to shoot again each time it is triggered. To stop an
ongoing Normal Speed Continuous Shutter operation,
press [SET].
With High-speed
Continuous Shutter
10 continuous shutter images will be shot when Auto
Shutter is triggered.
With Flash
Continuous Shutter
3 continuous shutter images will be shot with flash when
Auto Shutter is triggered.
To Next Page
Loading...
Need help?
General
