PRINTING IMAGES
189
To configure print settings for a single
image
1.
In the PLAY mode, press [MENU].
2.
Select the “PLAY” tab,
select “DPOF”, and
then press [왘].
3.
Use [왖] and [왔] to select “Select images”,
and then press [왘].
4.
Use [왗] and [왘] to
display the image you
want.
5.
Use [왖] and [왔] to specify the number of
copies.
• You can specify up to 99 for the number of copies.
Specify 00 if you do not want to have the image
printed.
6.
To turn on date
stamping for the
prints, press [BS] so
“On” is displayed.
•“On” indicates that date
stamping is turned on.
• Turning on date stamping
while “00” is specified for
the number of copies will
cause the number of copies to change to “01”. Any
other number of copies setting will remain the same
when you turn on date stamping.
• To turn off date stamping for the prints, press [BS] so
“Off” is displayed.
• Repeat steps 4 through 6 if you want to configure
other images for printing.
7.
After all the settings are the way you want,
press [SET] to apply them.
To Next Page
Loading...
Need help?
General
