– 11 –
COMP
•To change the decimal point and separator symbol set-
ting, press the
F key a number of times until you reach
the setup screen shown below.
• Display the selection screen.
1 r r
• Press the number key (
1 or 2) that corresponds to
the setting you want to use.
1(Dot): Period decimal point, comma separator
2(Comma): Comma decimal point, period separator
k Initializing the Calculator
• Perform the following key operation when you want to
initialize the calculation mode and setup, and clear re-
play memory and variables.
A B 3(All) =
Basic Calculations
k Arithmetic Calculations
Use the F key to enter the COMP Mode when you
want to perform basic calculations.
COMP .............................................................
F 1
• Negative values inside of calculations must be enclosed
within parentheses. For details, see “Order of Operations.”
• It is not necessary to enclose a negative exponent within
parentheses.
sin 2.34 10
–5
→ S 2.34 e D 5
• Example 1: 3(510
–9
)
1.5
10
–8
3 - 5 e D 9 =
• Example 2: 5(97)
80
5 - R 9 + 7 T =
•You can skip all T operations before =.
1
Disp
To Next Page
Loading...
Need help?
General
