— 20 —
7. TROUBLESHOOTING
130CR
1
2
3
4
5
6
7
Symptom/Problem
E01 appears on the display.
E94 appears on the display.
No date or time on receipt.
Paper is not advancing enough.
Drawer opens up after ringing
up only one time.
Not clearing totals at end of day
after taking report.
Programming is lost whenever
register is unplugged or there is
a power outage.
Register is inoperative.
Can’t get money out of drawer.
Most common causes
Changing modes without
completing transaction.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as
a single item dept.
Using X mode to take out reports.
Bad or no batteries.
No power.
Solutions
Return mode switch to
where it stops buzzing and
press
CA AMT
= TEND
.
Remove jammed paper.
Turn Mode switch to OFF
then turn to ON, or Turn
power OFF and then turn
power ON.
Program printer to print
receipts.
Program the dept. as a
normal dept.
Use Z mode to take out
reports.
Put in new batteries.
Pull lever underneath
register at rear.
PCR262/CE160
1
2
3
4
5
6
7
8
Symptom/Problem
E01 appears on the display.
E08 appears on the display.
E94 appears on the display.
No date or time on receipt.
Paper is not advancing enough.
Drawer opens up after ringing
up only one time.
Not clearing totals at end of day
after taking report.
Programming is lost whenever
register is unplugged or there is
a power outage.
Register is inoperative.
Can’t get money out of drawer.
Most common causes
Changing modes without
completing transaction.
Sign on operation is not
perfomed.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as
a single item dept.
Using X mode to take out reports.
Bad or no batteries.
No power.
Solutions
Return mode switch to
where it stops buzzing and
press
CA AMT
= TEND
.
Prior to starting registration
of any other operation,
press “1” ~ “8” and then
CA AMT
= TEND
.
Remove jammed paper. Turn
Mode switch to OFF then turn
to ON, or Turn power OFF
and then turn power ON.
Program printer to print
receipts.
Program the dept. as a
normal dept.
Use Z mode to take out
reports.
Put in new batteries.
Pull lever underneath
register at rear.