— 3 —
2. MACHINE INTIALIZATION
2-1. Initialization and loading memory protection battery
Note: You must initialize the cash register and install the memory protection batteries before you can
program the cash register.
To initialize the cash register
1. Set the mode switch to OFF.
2. Plug the power cord of the cash register into an AC outlet.
3. Load the memory protection batteries.
4. Set the mode switch to REG.
To load the memory protection batteries
1. Remove the printer cover.
2. Open the battery compartment cover.
3. Load 3 new UM-3, R6P (SUM-3) or LR6 (AM-3) type batteries into the compartment.
Be sure that the plus (+) and minus (–) ends of each battery are facing in the directions indicated by
the illustrations inside the battery compartment.
4. Slide the memory protection battery compartment cover back into place.
5. Replace the printer paper and printer cover.
REPLACE MEMORY PROTECTION BATTERIES AT LEAST ONCE EVERY YEAR.
2-2. To select the date format and monetary mode (130CR only)
You can select the date format and the monetary mode after initialization depending on the requirements in your
area.
Default date format is Day/Month/Year.
Default Monetary Mode is Add 2.
Example: Change the date format to Month/Day/Year, and the monetary mode to Add 0.
1. Set the mode switch to PGM.
2. Press the following keys.
A
Date format selections
Year/Month/Day
0
Month/Day/Year
1
3
Day/Month/Year
2
B
Monetary mode selections
Add 0 (0. )
0
Add 1 (0.0 )
1
Add 2 (0.00 )
2
P3 appears in mode display
SUB
TOTAL
0 1 2 2
Program set code number
SUB
TOTAL
1 0
Select numbers from
lists A and B.
(To end the setting)
SUB
TOTAL
CA AMT
= TEND
To Next Page
Loading...
Need help?
General
