Getting Ready
E-12
z Use a conveniently located power outlet that you can reach easily when you need to unplug the
projector.
z Do not allow any objects to be within the area indicated by the dashed line below, which is an area
within 30cm (11.8 inches) of the projector. Keep all obstacles and other objects at least 30cm away
from the projector’s vents.
z Airflow from air conditioning equipment can blow the heat being exhausted from the area around the
projector’s lens in a way that causes heat ripples to appear in the projected image. If this happens,
adjust the airflow of the air conditioning equipment or move the projector.
1. Lift up the front of the projector and press the release button 1.
z This will cause the front foot
2
to extend from the projector.
2. While holding down the release button, raise and lower the front of the projector.
When the front foot is approximately the height you want, release the release
button.
z The front foot will lock at the position where you release the release button.
Setup Precautions
Changing the Projector Elevation Angle
Intake vents
Exhaust vents
30cm
(11.8 inches)
Airflow vents
3
2 1
XJ-M_Setup_03_e.fm 12 ページ ２０１１年２月７日 月曜日 午後５時４４分
To Next Page
Loading...
Need help?
General
Weight and Dimensions
