10
Timer/Minute Minder
The hob is equipped with a timer that allows a finish time to be set for
the end of cooking on any zone, between a minimum of one minute
and a maximum of 99 minutes. This timer can be used separately for
each zone, and an LED will indicate the zone positions for each of the
active timers. Once the timers are set, the timer display will show the
time remaining on the first zone to finish cooking. The timer can also
be used as a minute minder to countdown time, when the zones are
not in use.
To set the timer
• First switch on the hob and set the zone to the power level
required.
• Touch the timer display. The display will show “0-” for approximately
ten seconds and the timer display LED will illuminate for the
required zone. If no timer is set, the timer display will become
inactive and the zone will continue cooking.
• Touch the slider control to set the individual minutes between 0
and 9. The selection will confirm in approximately 2 seconds, the
display will show “–” and the minutes set.
• Touch the slider control again to set the tens of minutes between 1
and 9. The selection will confirm in approximately 2 seconds, the
timer display will show the timer set and the countdown will start.
At the end of the timer, the selected zone will switch o, the timer
display and the zone timer LED will flash. The hob will beep for
approximately two minutes. To switch o the beep and the flashing
displays, touch any key.
To Next Page
Loading...
Need help?
General
