CDA WC370 User Manual

Care and Maintenance
Before beginning any care or maintenance, you should always disconnect the
appliance from the electricity supply, and also turn off the water supply.
Door seals
Wipe the dishwasher door seals regularly with a damp cloth to remove
any residues.
Filters
You should clean the filters at least once a month.
1. Remove the lower basket.
2. Turn the microfilter anticlockwise and then lift it out as in figure 9.
3. Remove the coarse lter from the microlter (gure 10).
4. Remove the base filter from the dishwasher compartment (figure 11).
You should clean and rinse the filters thoroughly before replacing all the
sections in reverse order to that above. The microfilter should lock into
place once it is secure as shown in figure 12.
Please note: Never run a programme without the filters in place.
Incorrect fitting of the filters may reduce wash performance and
potentially damage your appliance.
Spray arms
You should clean the spray arms at least once a month.
1. Remove the lower basket
2. Pull the lower spray arm upwards to remove it.
3. To remove the upper spray arm, first remove the nut on the upper spray
arm by turning it as in figure 9.
You should clean and rinse the spray arms thoroughly before replacing
them. Ensure that the upper spray arm nut is securely tightened when
refitting the upper spray arm.
Dishwasher interior
To deal with an accumulation of dirt, oil or limescale in the dishwasher, run
an intensive programme with detergent when the dishwasher is empty.
Alternatively, there are specialist dishwasher cleaners available that can be used.
fig 9
g 10
fig 11
20
ENGLISH
MAINTENANCE AND CLEANING
Cleaning the machine in regular intervals prolongs the machine's service life.
Oil and lime may accumulate in the machine's washing section. In case of such
accumulation;
Cleaning the seals in the machine door,
Cleaning the machine,
Filters
-Fill the detergent compartment without loading any dishes into the machine, select a
programme that runs at high temperature, and start the machine. In case of insufficiency, use
special cleansing material available in the market. (Cleansing material produced special to
machines by detergent producers.)
-To clean any accumulated residues in the door seals, wipe the seals regularly by using a
dampened cloth.
Clean the filters and spray arms at least once a week.
Unplug your machine and turn off its tap before starting the cleaning.
Do not use hard materials when cleaning your machine. Wipe with a fine cleaning material
and a dampened cloth.
Check if any food wastes have remained on the coarse and fine
filters.
If any food wastes are left, remove the filters and clean them
thoroughly under the water tap.
a. Micro Filter
b. Coarse Filter
c. Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
clockwise and take it out by lifting upwards.1
Pull and remove the metal/plastic
filter. 3 Then pull the coarse filter out
of the micro filter.2 Rinse it with lots of
water under the tap. Refit the
metal/plastic filter. Insert the coarse
filter into the micro filter in a way that
the marks will correspond to one
another. Attach micro filter into the
metal/plastic filter and turn to the
direction of arrow and it is locked
when the arrow on micro filter can be
seen from across. 4
• Never use your dishwasher without any filter.
• Incorrect fitting of the filter will reduce the washing effectiveness.
• Clean filters are very important in terms of the proper running of the machine.
20
ENGLISH
MAINTENANCE AND CLEANING
Cleaning the machine in regular intervals prolongs the machine's service life.
Oil and lime may accumulate in the machine's washing section. In case of such
accumulation;
Cleaning the seals in the machine door,
Cleaning the machine,
Filters
-Fill the detergent compartment without loading any dishes into the machine, select a
programme that runs at high temperature, and start the machine. In case of insufficiency, use
special cleansing material available in the market. (Cleansing material produced special to
machines by detergent producers.)
-To clean any accumulated residues in the door seals, wipe the seals regularly by using a
dampened cloth.
Clean the filters and spray arms at least once a week.
Unplug your machine and turn off its tap before starting the cleaning.
Do not use hard materials when cleaning your machine. Wipe with a fine cleaning material
and a dampened cloth.
Check if any food wastes have remained on the coarse and fine
filters.
If any food wastes are left, remove the filters and clean them
thoroughly under the water tap.
a. Micro Filter
b. Coarse Filter
c. Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
clockwise and take it out by lifting upwards.1
Pull and remove the metal/plastic
filter. 3 Then pull the coarse filter out
of the micro filter.2 Rinse it with lots of
water under the tap. Refit the
metal/plastic filter. Insert the coarse
filter into the micro filter in a way that
the marks will correspond to one
another. Attach micro filter into the
metal/plastic filter and turn to the
direction of arrow and it is locked
when the arrow on micro filter can be
seen from across. 4
• Never use your dishwasher without any filter.
• Incorrect fitting of the filter will reduce the washing effectiveness.
• Clean filters are very important in terms of the proper running of the machine.
20
ENGLISH
MAINTENANCE AND CLEANING
Cleaning the machine in regular intervals prolongs the machine's service life.
Oil and lime may accumulate in the machine's washing section. In case of such
accumulation;
Cleaning the seals in the machine door,
Cleaning the machine,
Filters
-Fill the detergent compartment without loading any dishes into the machine, select a
programme that runs at high temperature, and start the machine. In case of insufficiency, use
special cleansing material available in the market. (Cleansing material produced special to
machines by detergent producers.)
-To clean any accumulated residues in the door seals, wipe the seals regularly by using a
dampened cloth.
Clean the filters and spray arms at least once a week.
Unplug your machine and turn off its tap before starting the cleaning.
Do not use hard materials when cleaning your machine. Wipe with a fine cleaning material
and a dampened cloth.
Check if any food wastes have remained on the coarse and fine
filters.
If any food wastes are left, remove the filters and clean them
thoroughly under the water tap.
a. Micro Filter
b. Coarse Filter
c. Metal/Plastic Filter
To remove and clean the filter combination, turn it counter
clockwise and take it out by lifting upwards.1
Pull and remove the metal/plastic
filter. 3 Then pull the coarse filter out
of the micro filter.2 Rinse it with lots of
water under the tap. Refit the
metal/plastic filter. Insert the coarse
filter into the micro filter in a way that
the marks will correspond to one
another. Attach micro filter into the
metal/plastic filter and turn to the
direction of arrow and it is locked
when the arrow on micro filter can be
seen from across. 4
• Never use your dishwasher without any filter.
• Incorrect fitting of the filter will reduce the washing effectiveness.
• Clean filters are very important in terms of the proper running of the machine.
fig 12
arm by turning it.
12

CDA WC370 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Stainless steel
Washing class	A
Noise level	52 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	16 L
Energy consumption per cycle	1.05 kWh

Weight and Dimensions

Depth	570 mm
Width	596 mm
Height	875 mm