CDA WC370 User Manual

Failure Codes and Troubleshooting
The programme indicators also serve as a diagnostic display to help in the event of a problem with the appliance.
13
Error Code Error description Advice
F1 Alarm is active against water overflow.
Turn off the dishwasher and disconnect the water supply.
Contact CDA service.
F2
The waste water in the machine can not be
discharged.
Drain hose is blocked.
The filters of your machine might be blocked.
Restart the dishwasher and cancel the programme.
If the error continues, contact CDA service.
F3 Continual fill error. Close the tap and contact CDA service
F4 Inadequate water supply.
Make sure the water inlet tap is fully open.
Close the water tap, separate the water inlet hose from the tap and
clean the filter.
Restart your machine, contact CDA service if the error resumes.
F5 Faulty heater sensor. Contact CDA service.
F6
Overheating error (temperature in the
machine is too high).
Contact CDA service.
F7 Heater error. Contact CDA service.
F8 Spray diverter position error. Contact CDA service.
F9 Faulty electronic card. Contact CDA service.

CDA WC370 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Stainless steel
Washing class	A
Noise level	52 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	16 L
Energy consumption per cycle	1.05 kWh

Weight and Dimensions

Depth	570 mm
Width	596 mm
Height	875 mm