CDA WC370 User Manual

Installation
• Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary.
• Only use the water inlet supplied with the appliance.
• If the water pressure is above 10 bar, a pressure relief valve should be used.
• After connecting the water supply, check to ensure there are no leaks.
• The water outlet can either be connected to a water drain or to a sink outlet
spigot. This connection should be at a minimum of 50 cm and a maximum
of 110 cm from the oor. The drain hose should be no longer than 4m in
length to ensure good performance from the dishwasher.
fig 14
fig 15
fig 16
fig. 13
fig. 13
40cm
fig. 15
Installation
• Do not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard so that it
can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary. The
dishwasher is equipped with an adjustable rear foot that can be raised or
lowered by means of an adjustment screw, located in the centre of the kick plate.
• Only use the water inlet supplied with the appliance.
• If the water pressure is above 10 bar, a pressure relief valve should be used.
• After connecting the water supply, check to ensure there are no leaks.
• The water outlet can either be connected to a water drain or to a sink outlet
spigot. This connection should be at a minimum of 50 cm and a maximum of
110 cm from the floor. The drain hose should be no longer than 4m in length
to ensure good performance from the dishwasher.
• To prevent siphoning, ensure that the water outlet is not pushed too far into
the waste standpipe. The lowest part of the water outlet should be level with
the bottom basket of the dishwasher.
• When connecting to the sink, ensure that the waste pipe runs higher than the
level of the sink bowl to prevent siphoning.
100cm
10cm recommended
fig. 14
16
4cm

CDA WC370 Specifications

General

Door color	Not applicable
Display type	LED
Appliance placement	Fully built-in
Control panel color	Stainless steel
Washing class	A
Noise level	52 dB
Number of place settings	12 place settings
Number of washing programs	5
Water consumption per cycle	16 L
Energy consumption per cycle	1.05 kWh

Weight and Dimensions

Depth	570 mm
Width	596 mm
Height	875 mm