CDA wc431 User Manual

11
Salt
To ensure the best efficiency, the
dishwasher needs soft water. Hard
water means that lime residues remain
on the dishes and the interior of the
dishwasher, affecting performance. The
softener system is designed to remove
the ions that make the water hard to
provide the best quality wash
performance. This is achieved by using
dishwasher salt.
To Add Dishwasher Salt, Follow the
Steps Below:
1. Remove the lower dishwasher
basket and then unscrew the
salt compartment cap, as shown
in figure 3.
2. Fill the compartment with
dishwasher salt (do not use
table salt), carefully to prevent unnecessary spillage (figure
4). Before first use, you should fill the compartment with 1kg
of dishwasher salt and then fill up the salt compartment
with water (up to the brim of the compartment) as shown in
figure 4.
3. Replace the cap and the lower basket.
When the salt warning light on the control panel illuminates, you
should refill the salt compartment with salt only – do not add water
to the salt compartment after the first use.
Important: You should run a prewash programme immediately
after adding dishwasher salt, to prevent any damage to the
dishwasher systems.
Only fill the salt compartment with water on first use.
Fig.4
Fig.3

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm