CDA wc431 User Manual

9
Cancelling a Programme
It is possible to cancel the programme once is has started.
• First open the door slightly to reduce the risk of water
spillage.
• Press and hold in the Programme Selection button for
three seconds until the end of programme indicator flashes
and a“1”shows on the display.
• Then close the door. The dishwasher will run a drain cycle
which will take approximately 30 seconds. Once this is
complete, the dishwasher will beep five times and the end
of programme light will switch on.
Switching the Dishwasher Off
Once the dishwasher beeps five times and the end of programme
light switches on, the dishwasher can be switched off by pressing
the Power button.
Then turn off the water tap and remove the plug from the power
socket.
Please note: the dishwasher will automatically continue on the
programme it has started if the door is opened or in the event
of a power cut.
Detergent
To Fill the Detergent Compartment
1. Push the latch to open the
compartment.
2. Add the required amount of
detergent. The main detergent
compartment “b” (figure 2)
has lines to allow for specific
amounts of detergent. These
are marked at either 15 cm
3
or
Fig.2

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm