CDA wc431 User Manual

12
Softener Adjustment
The efficiency of your dishwasher
depends on the softness of the tap
water.
To ensure best efficiency, the
dishwasher is equipped with a system
that reduces the hardness in the mains
water supply. The efficiency will increase
when the system is correctly set. To find
out the water hardness level of your
water supply you can use the test strip
supplied or alternatively contact your
local water board.
• Open the testing strip (figure 5).
• Run water through the tap for one
minute.
• Hold the testing strip in water for
one second.
• Remove from the water and
shake the test strip to remove
excess water.
• Wait for one minute.
• Check the number of marks on
the strip to see the level of water
hardness.
If the hardness of the water you use is
above 63 dE or if you are using well
water; you are recommended to contact
your local water board to confirm the
water hardness level and to use filter and
water refinement devices.
Please note: The level of water
Fig.5

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm