CDA wc431 User Manual

25
Installation
• Do not install this appliance if it is
damaged in any way. Installing a
damaged appliance may
invalidate the warranty.
• The water supply tap should be
located in an adjacent cupboard
so that it can be accessed after
installation.
• Ensure the appliance is level by
adjusting the feet as necessary.
The dishwasher is equipped with
an adjustable rear foot that can
be raised or lowered by means
of an adjustment screw, located
in the centre of the kick plate.
• Only use the water inlet supplied
with the appliance.
• If the water pressure is above 10
bar, a pressure relief valve
should be used.
• After connecting the water
supply, check to ensure there
are no leaks.
• The water outlet can either be
connected to a water drain or to
a sink outlet spigot. This
connection should be at a
minimum of 50 cm and a
maximum of 110 cm from the
floor. The drain hose should be
no longer than 4m in length to
ensure good performance from
the dishwasher.
• To prevent syphoning, ensure

CDA wc431 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	52 dB
Delay start (max)	9 h
Delayed start timer	Yes
Dishwashing programs	Eco, Intensive, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	6
Drying class	A
Annual energy consumption	237 kWh
Water consumption per cycle	13 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm