CDA WC461 User Manual

7
Salt
To ensure the best efficiency, the dishwasher needs soft water. Hard water
means that lime residues remain on the dishes and the interior of the
dishwasher, affecting performance. The softener system is designed to
remove the ions that make the water hard to provide the best quality wash
performance. This is achieved by using dishwasher salt.
To add dishwasher salt, follow the steps below:
1. Remove the lower dishwasher basket and then unscrew the salt
compartment cap, as shown in figure 3.
2. Fill the compartment with dishwasher salt (do not use table salt),
carefully to prevent unnecessary spillage (figure 4). Before first use, you
should fill the compartment with 1kg of dishwasher salt and then fill up
the salt compartment with water (up to the brim of the compartment) as
shown in figure 4.
3. Replace the cap and the lower basket.
When the salt warning light on the control panel illuminates, you should
refill the salt compartment with salt only – do not add water to the salt
compartment after the first use.
Important:
You should run a prewash programme immediately after adding dishwasher
salt, to prevent any damage to the dishwasher systems.
Only fill the salt compartment with water on first use.
fig. 3
fig. 4

CDA WC461 Specifications

General

Door color	Not applicable
Built-in display	No
Appliance placement	Fully built-in
Control panel color	Black, Stainless steel
Noise level	47 dB
Delay start (max)	19 h
Delayed start timer	Yes
Dishwashing programs	Auto 60-70°C, Glass/delicate, Eco, Intensive, Normal, Pre-wash, Quick
Number of place settings	10 place settings
Number of washing programs	8
Drying class	A
Annual water consumption	3360 L
Annual energy consumption	237 kWh
Water consumption per cycle	12 L
Energy consumption per cycle	0.83 kWh

Weight and Dimensions

Depth	570 mm
Width	448 mm
Height	870 mm