8
Softener Adjustment
The efficiency of your dishwasher depends on the softness of the tap water.
To ensure best efficiency, the dishwasher is equipped with a system that
reduces the hardness in the mains water supply. The efficiency will increase
when the system is correctly set. To find out the water hardness level of your
water supply you can use the test strip supplied or alternatively contact your
local water board.
1. Open the testing strip (figure 5).
2. Run water through the tap for one minute.
3. Hold the testing strip in water for one second.
4. Remove from the water and shake the test strip to remove excess water.
5. Wait for one minute.
6. Check the number of marks on the strip to see the level of water
hardness.
If the hardness of the water you use is above 63 dE or if you are using well
water; you are recommended to contact your local water board to confirm
the water hardness level and to use filter and water refinement devices.
Please note: The level of water hardness is preset to level 3.
1. Press and hold down the programme selection button
2. Press the Power button to switch on the dishwasher
3. Keep the programme selection button pressed until “SL” shows on the
display and then disappears
4. To adjust the level, press the programme selection button until the
required level is shown on the display, as listed in the Table of Water
Hardness below.
5. To store the selected water hardness level, press the power button.
Water hardness level British hardness dE Display shows
1 0-6 L1
2 7-14 L2
3 15-21 L3
4 22-28 L4
5 29-39 L5
6 40-63 L6
fig. 5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
